|
A crow-stepped gable, stepped gable, or corbie step is a stairstep type of design at the top of the triangular gable-end of a building. The top of the parapet wall projects above the roofline and the top of the brick or stone wall is stacked in a step pattern above the roof as a decoration and as a convenient way to finish the brick courses. Early examples, from the 15th century onwards, are found in Denmark, England, Estonia, Germany, Latvia, Lithuania, Switzerland, and Sweden. Crow-stepped gables were also used in Scotland as early as the 16th century.〔''Tolbooths and Townhouses: Civic Architecture in Scotland to 1833'', Tolbooth Museum, Stonehaven〕 Examples of Scottish crow-stepped gable can be seen at Muchalls Castle, Monboddo House, and the Stonehaven Tolbooth, all late 16th- and early 17th-century buildings. Crow-stepped gables are also common on Danish medieval churches. 19th-century examples are found in North America, and the step gable is also a feature of the northern-Renaissance Revival and Dutch Colonial Revival styles. ==Construction== Convenient access to the roof ridge motivated the crow-step design, along with the availability of squarish stones to accomplish this form of construction. The access would have been convenient for chimney sweeps and roofers in earlier times, where cranes were non-existent and tall ladders were not common. With crow steps, the roofing slates (rarely tiles) do not reach the end of the building, so making for a special problem with keeping the roof watertight.〔C. Michael Hogan, ''History of Muchalls Castle'', Lumina Press, Aberdeen (2005)〕 Many different schemes are found for overcoming this, some of which are described below. Terms currently used in Scotland are italicised. * Slates may be laid to the edge of the crow step, with the last slate raised by a wedge (''tilting fillet''). Then mortar (lime mortar or cement) would be laid over the edge of the slate to seal the gap. Other solutions involve working with lead. * A groove approximately 25 mm (1 inch) deep is cut into the inside edge of the steps. A lead abutment flashing is inserted into this groove, called a chase or a ''raggle''. The lead is laid over the end slate, which is raised by a tilting fillet. * Leading is inserted into a raggle, and used to make a trough, or secret gutter, running down the inside edge of the steps. The far edge of the trough is raised over a triangular fillet. Slates are then laid resting on that trough edge and overlapping into the trough, which is open and runs directly down to gutters (''roans''). * Rather than forming a raggle, lead flashings may be placed into the joints between bricks as they are laid. When lead is to be held into a raggle, small folded lead wedges called ''bats'' are inserted at intervals and hammered in so they expand. The raggle is then sealed with mortar. Crow steps are frequently made of sandstone, even on buildings otherwise of granite,〔 *Tranter, Nigel, ''The Fortified House in Scotland'', Volume IV, pp 167-169, Oliver & Boyd (1962 to 1971)〕 and it is said that the porous nature of sandstone leads to problems with water penetration. Because of this, crow steps are sometimes capped with lead or sealed with other materials. 抄文引用元・出典: フリー百科事典『 ウィキペディア（Wikipedia）』 ■ウィキペディアで「Crow-stepped gable」の詳細全文を読む スポンサード リンク
|